Fuji Xerox Phaser 5500 Service Manual page 188

Jam at F (Compile Exit Sensor OFF) Troubleshooting Procedure (Continued)
Step Actions and Questions
7 Check Compiler Harness continuity.
1. Disconnect P/J8320 and P/J8391.
2. Check for continuity at the following:
P/J8320-3 <=> J8391B-1
P/J8320-2 <=> J8391B-2
P/J8320-1 <=> J8391B-3
Are these conductive?
8 Check Main Sensor Harness continuity.
1. Disconnect P/J8391 from the harness,
and P/J8302A on the Finisher Main
PWB.
2. Check for continuity at the following:
J8391A-3 <=> J8302A-4
J8391A-2 <=> J8302A-5
J8391A-1 <=> J8302A-6
Are these conductive?
9 Check for +5 V to the Compile Exit Sensor.
Is there +5 V across J8302A-6 <=>
J8302A-4 on the Finisher Main PWB?
10 Check Compile Exit Sensor signal.
Does the voltage across P8302A-5 <=>
P8302A-4 on the Finisher Main PWB
change when the actuator is operated?
11 Test the Exit Motor.
Run the Service Diagnostics Finisher Exit
Motor Test.
Does the motor rotate normally?
12 Test the Lower Exit Roller Drive.
Run the Service Diagnostics Finisher Exit
Motor CCW test.
Do the Exit Rollers rotate?
13 Print a Test Print.
Does the error still occur?
14 Check Exit Motor harness connections.
Are P/J8334 and P/J8304 connected?
15
Print a Test Print.
Does the error still occur?
3-110
Yes
Go to Step 8.
Go to Step 9.
Go to Step 10.
Replace the
Finisher Main
PWB
(page 3-248).
Replace the
Finisher Main
PWB
(page 3-248).
Go to Step 14.
Go to Step 14.
Go to Step 16.
Go to Step 16.
Phaser 5500 Printer Service Manual
No
Repair the
Compiler
Harness.
Repair the Main
Sensor Harness.
Replace the
Finisher Main
PWB
(page 3-248).
Replace the
Compile Exit
Sensor
(page 3-189).
Go to Step 12.
Restore operation
and go to Step
13.
Problem solved.
Connect and go
to Step 15.
Problem solved.