Fuji Xerox Phaser 5500 Service Manual page 144

Jam at Tray 5 (Feed Out Sensor #5) Troubleshooting Reference
Applicable Parts
Feed Roller
Retard Roller
Nudger Roller
Engine Logic Board
Tray 4-5 PWB
Tray 5 Pre-Feed
Sensor
Feed Out Sensor #5
Jam at Tray 5 (Feed Out Sensor #5) Troubleshooting Procedure
Step Actions and Questions
1 Check paper condition.
Is the paper in the tray damaged?
2
Check paper size settings.
Does the paper size match the setting?
3 Remove the tray and check the rollers.
Is the Feed, Retard, or Nudger Roller
worn or contaminated with paper dust?
4 Check paper position at Door C.
Does the paper touch the Tray 5 Pre-
Feed or Feed Out Sensor #5?
5 Test the Tray 5 Pre-Feed Sensor.
1. Open Door C.
2. Run the Service Diagnostics Tray 5
Pre-Feed Sensor test.
Does the sensor change state?
6 Check the Tray 5 Pre-Feed Sensor
connection.
Are P/J103A, P/J661A and P/J549A
connected?
7
Check continuity between the Tray 5 Pre-
Feed Sensor and Tray 4-5 PWB.
Is there continuity on each wire
between P/J103A <=> P/J549A?
8 Check for +5 V at Tray 5 Pre-Feed Sensor
Is there +5 V across the sensor
connector's Pin 1 <=> ground?
9
Check connections between the Tray 4-5
PWB and Engine Logic Board.
Are P/J541 and P/J413 connected?
3-66
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
1000-Sheet Feeder P/J Locator (page 5-5)
1000-Sheet Tray 4 & 5 Wiring (page 5-9)
PL20.4 Tray 4-5 Feeder (2/2) (page 4-10)
PL20.6 Tray 4-5 Drive and Electrical (page 4-16)
Phaser 5500 Printer Service Manual
Yes
Replace the
paper.
Go to Step 3.
Clean or replace
the Rollers.
Remove the
paper.
Go to Step 12.
Go to Step 7.
Go to Step 8.
Replace the
sensor.
Go to Step 10.
No
Go to Step 2.
Correct paper
size settings.
Go to Step 4.
Go to Step 5.
Go to Step 6.
Connect the
sensor.
Repair the wiring.
Go to Step 9
Connect P/J541
and P/J413.