Fuji Xerox Phaser 5500 Service Manual page 189

Jam at F (Compile Exit Sensor OFF) Troubleshooting Procedure (Continued)
Step Actions and Questions
16
Check Exit Motor Harness continuity.
1. Disconnect P/J8334 and P/J8304.
2. Check for continuity at the following:
P/J8334-1 <=> P/J8304-2
P/J8334-2 <=> P/J8304-4
P/J8334-3 <=> P/J8304-1
P/J8334-4 <=> P/J8304-3
P/J8334-5 <=> P/J8304-6
P/J8334-6 <=> P/J8304-5
Are these conductive?
17 Check Exit Motor resistance.
Is there some amount of resistance
across P8334-2/5(COM) and P8334-1/3/
4/6?
18 Check for +24 V to the Exit Motor.
Is there +24 V across J8304-4 <=>
ground and J8304-6 <=> ground on the
Finisher Main PWB?
19 Replace the Exit Motor.
Print a Test Print.
Does the error still occur?
Error Messages, Codes, and Procedures
Yes
Go to Step 17.
Go to Step 18.
Go to Step 19.
Replace the
Finisher Main
PWB
(page 3-248).
No
Repair the Main
Drive Harness.
Replace the Exit
Motor
(page 3-243).
Replace the
Finisher Main
PWB
(page 3-248).
Problem solved.
3-111