Fuji Xerox Phaser 5500 Service Manual page 319

Door D Open (Door D Interlock Switch) Troubleshooting Procedure (Continued)
Step Actions and Questions
2
Test the Door D Interlock Switch.
Run the Service Diagnostics Door D
Interlock Switch test.
Does the sensor state change each time
the switch is pressed?
3 Check the switch connections.
Are J124 and P/J541 connected?
4 Check continuity between the switch and
the Duplex PWB.
Is there continuity on each wire
between J124 <=> P/J541?
5 Check for +5 V to the switch.
Is there +5 V across J124-2 <=> ground?
6 Check the Duplex PWB connection.
Are P/J540 and P/J417 connected?
7 Check continuity between the Duplex PWB
and the Engine Logic Board.
1. Disconnect P/J540 and P/J417.
2. Check for continuity at the following:
P/J540-1 <=> P/J417-A1
P/J540-2 <=> P/J417-B1
P/J540-3 <=> P/J417-A2
P/J540-4 <=> P/J417-B2
P/J540-5 <=> P/J417-A3
P/J540-6 <=> P/J417-B3
P/J540-7 <=> P/J417-A4
P/J540-8 <=> P/J417-B4
Are these conductive?
8 Check for +5 V to the Duplex PWB.
Is there +5 V across P/J540-1 (+) <=>
ground?
Error Messages, Codes, and Procedures
Yes
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 4.
Go to Step 5.
Replace the
switch
(page 3-74).
Go to Step 7.
Go to Step 8.
Replace the
Duplex PWB
(page 3-77).
No
Go to Step 3.
Connect P/J124
and P/J541.
Repair the wiring.
Go to Step 6.
Connect P/J540
and P/J417.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
3-241