Tray 6 Failure - H1-5 Tray 6 Fail - Fuji Xerox Phaser 5500 Service Manual

Tray 6 Failure - H1-5 Tray 6 Fail

Detected lift failure or paper size detection inoperative.
Applicable Error Code
Tray 6 Failure - H1-5 Tray 6 Fail
Tray 6 Failure Troubleshooting Reference
Applicable Parts
Tray In Sensor
Tray 6 Main Harness
Tray 6 Feeder
Harness
Tray 6 PWB
Lift Cables
Feed/Lift Motor
Nudger Solenoid
Level Sensor
Engine Logic Board.
Tray 6 Failure Troubleshooting Procedure
Step Actions and Questions
1 Check Tray In Sensor alignment.
Pull the Tray out.
Does the actuator enter the sensing
area of the Tray Set Sensor, or is it
deformed or damaged?
2 Check the Tray installation.
Is the Tray installed correctly?
3 Check the repairs.
Does the error reoccur?
4
Test the Tray In Sensor.
Run the Service Diagnostics Tray In
Sensor test.
Does the sensor status change when
the tray is moved in and out?
5
Check the Tray In Sensor Main Harness
connection.
Are PF53 and JF01 connected?
3-144
References
Print Engine P/J Engine Logic Board (page 10-13)
PL2.1 Tray (1/2) and Feeder (1/2) (page 9-8)
PL2.2 Tray (2/2) (page 9-10)
PL2.3 Feeder (2/2) (page 9-12)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
2000-Sheet Tray 6 Feeder P/J Locator (page 5-20)
2000-Sheet Tray 6 Drive P/J Locator (page 5-21)
2000-Sheet Tray 6 Sensors Wiring (page 5-24)
2000-Sheet Tray 6 Drive Wiring (page 5-25)
PL22.1 Tray 6 Covers (page 4-18)
PL23.3 Tray (2/2) (page 4-20)
PL22.4 Tray 6 Feeder (1/3) (page 4-24)
PL22.5 Tray 6 Feeder (2/3) (page 4-26)
PL22.8 Tray 6 Electrical (page 4-32)
Phaser 5500 Printer Service Manual
Yes
Go to Step 2.
Go to Step 3.
Go to Step 4.
Go to Step 10.
Go to Step 7.
No
Repair the
damage and go
to Step 2.
Correct and go to
Step 3.
Problem solved.
Go to Step 5.
Connect and go
to Step 6.