Fuji Xerox Phaser 5500 Service Manual page 192

Jam at F or G (Compile Exit Sensor ON) Troubleshooting Procedure (Continued)
Step Actions and Questions
16 Check Main Drive Harness continuity.
1. Disconnect P/J8335 and P/J8304.
2. Check for continuity at the following:
P/J8335-1 <=> P/J8304-7
P/J8335-2 <=> P/J8304-8
P/J8335-3 <=> P/J8304-9
P/J8335-4 <=> P/J8304-11
P/J8335-5 <=> P/J8304-10
P/J8335-6 <=> P/J8304-13
Are these conductive?
17 Check Registration Motor resistance.
Is there some amount of resistance
across P8335-2/5(COM) and P8335-1/3/
4/6?
18 Check for +24 V to the Registration Motor.
Is there +24 V across J8304-8 <=>
ground and J8304-10 <=> ground on the
Finisher Main PWB?
19 Replace the Registration Motor.
Print a Test Print.
Does the error still occur?
20 Test the Compile Exit Sensor.
Run the Service Diagnostics Compile Exit
Sensor test.
Does the sensor state change?
21 Check the Compile Exit Sensor
connection.
Are P/J8320 and P/J8391 connected?
22 Print a Test Print.
Does the error still occur?
23 Check Main Sensor Harness connections.
Are P/J8391 and P/J8302A connected?
24 Print a Test Print.
Does the error still occur?
25
Check Compiler Harness continuity.
1. Disconnect P/J8320 and P/J8391.
2. Check for continuity at the following:
P/J8320-3 <=> J8391B-1
P/J8320-2 <=> J8391B-2
P/J8320-1 <=> J8391B-3
Are these conductive?
3-114
Yes
Go to Step 17.
Go to Step 18.
Go to Step 19.
Replace the
Finisher Main
PWB
(page 3-248).
Replace the
Finisher Main
PWB
(page 3-248).
Go to Step 23.
Go to Step 23.
Go to Step 25.
Go to Step 25.
Go to Step 26.
Phaser 5500 Printer Service Manual
No
Repair the Main
Drive Harness.
Replace the
Registration
Motor
(page 3-245).
Replace the
Finisher Main
PWB
(page 3-248).
Problem solved.
Go to Step 21.
Connect and go
to Step 22.
Problem solved.
Connect and go
to Step 24.
Problem solved.
Repair the
Compiler
Harness.