Tray N Failure - H8-1, 2 Tray Size Sensor Broken - Fuji Xerox Phaser 5500 Service Manual

Tray N Failure - H8-1, 2 Tray Size Sensor Broken

Paper size detection has failed in Tray 2 or Tray 3.
Applicable Error Codes
Tray 2 Failure - H8-1 Tray 2 Size Sensor Broken
Tray 3 Failure - H8-2 Tray 3 Size Sensor Broken
Tray Failure (Tray 2-3 Paper Size Switch) Troubleshooting Reference
Applicable Parts
Paper Size
Switch
Engine Logic
Board
Tray Failure (Tray 2-3 Paper Size Switch) Troubleshooting Procedure
Step Actions and Questions
1
Check the Paper in the affected tray.
Is paper loaded in the tray properly?
2 Check the Paper Size Switch for the
affected tray.
Is the switch installed correctly?
3 Test the Paper Size Switch for the affected
tray.
Run the Service Diagnostics Size Sensor
test for the affected tray.
Does the sensor state change each time
the loaded tray is moved in or out?
4 Check the Paper Size Switch connection.
For Tray 2:
Are P/J109 and P/J412 connected?
For Tray 3:
Are P/J110 and P/J412 connected?
Error Messages, Codes, and Procedures
References
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine P/J Locator Electrical (page 10-12)
PL2.1 Tray (1/2) Feeder (1/2) (page 9-8)
PL8.1 Print Engine Electrical (page 9-40)
Yes
Go to Step 2.
Go to Step 3.
Reconnect the
connector of the
Engine Logic
Board.
Go to Step 5.
No
Reload the paper.
Correct the
installation.
Go to Step 4.
Connect the
Paper Size
Switch.
3-193