Fuji Xerox Phaser 5500 Service Manual page 172

Jam at F (H-X'port Exit Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Test the H-'Xport Exit Sensor.
1. Open Door F.
2. Run the Service Diagnostic H-'Xport Exit
Sensor test.
Does the sensor change state?
2 Check the H-'Xport Harness connections.
Is the harness connected to the Exit
Sensor and Finisher correctly?
3 Print a Test Print.
Does the error still occur?
4 Check the H-'Xport Harness continuity.
1. Disconnect the Exit Sensor (J8381) and
P8372 on the H-'Xport PWB.
2. Check for continuity at the following:
P8372-4 <=> J8381-3
P8372-5 <=> J8381-2
P8372-6 <=> J8381-1
Are these conductive?
5 Check for +5 V to the H-'Xport Exit Sensor.
Is there +5 V across J8372-6 <=> J8372-
4 on the H-'Xport PWB?
6 Check the H-'Xport Exit Sensor signal.
Does the voltage across J8372-5 <=>
J8372-4 on the H-'Xport PWB change
when the sensor actuator is operated?
7 Check the H-'Xport Motor.
Run the Service Diagnostics H-'Xport
Motor test.
Does the motor rotate normally?
8 Test the H-'Xport Motor connections.
Is the H-'Xport Motor correctly
connected to the harness?
9 Print a Test Print.
Does the error still occur?
3-94
Yes
Go to Step 7.
Go to Step 4.
Go to Step 4.
Go to Step 5.
Go to Step 6.
Replace the H-
'Xport PWB
(page 3-247).
Replace the H-
'Xport PWB
(page 3-247).
Go to Step 10.
Go to Step 10.
Phaser 5500 Printer Service Manual
No
Go to Step 2.
Reconnect and
go to Step 3.
Problem solved.
Repair the
harness.
Replace the H-
'Xport PWB
(page 3-247).
Replace the H-
'Xport Exit
Sensor
(page 3-118).
Go to Step 8.
Connect and go
to Step 9.
Problem solved.