Close Door G - Door G Is Open - Fuji Xerox Phaser 5500 Service Manual

Close Door G - Door G is Open

The Door G Interlock Switch behind the Finisher Front Door indicates Door G is
open.
Door G Open (Door G Interlock Switch) Troubleshooting Reference
Applicable Parts
Finisher Front
Cover
Door G Interlock
Switch
Interlock Harness
Eject Cover Sensor
Finisher Main PWB
Engine Logic
Board.
Door G Open (Door G Interlock Switch) Troubleshooting Procedure
Step Actions and Questions
1 Check Door G operation.
Does Door G open and close smoothly?
2 Check the Door G Interlock Switch
installation.
Is the sensor installed correctly?
3
Test the Door G Interlock Switch.
Run the Service Diagnostics Door G
Interlock Switch test.
Does the sensor state change when
Door G is opened and closed?
4
Check the Door G Interlock Harness
connections.
Are J8365 on the harness, J8364 on the
Eject Cover SW, and J8388 and J8314
on the Finisher Main PWB connected?
5
Cycle printer power.
Does the error still occur?
Error Messages, Codes, and Procedures
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
Finisher P/J Locator Door G Interlock (page 5-30)
Finisher Main PWB P/J Locator (page 5-35)
Finisher Power Wiring (page 5-38)
PL25.5 Finisher Covers (2/2) (page 4-52)
PL25.9 Finisher Eject (1/3) (page 4-60)
PL25.14 Finisher Electrical (1/2) (page 4-70)
PL25.15 Finisher Electrical (2/2) (page 4-72)
Yes
Go to Step 2.
Go to Step 3.
Go to Step 9.
Go to Step 6.
Go to Step 6.
No
Correct the
installation.
Correct the
installation.
Go to Step 4.
Connect and go
to Step 5.
Problem solved.
3-245