Fuji Xerox Phaser 5500 Service Manual page 142

Jam at Tray n (Feed Out Sensor #4) Troubleshooting Reference
Applicable Parts
Feed Roller
Retard Roller
Nudger Roller
Engine Logic Board
Tray 4-5 PWB
Tray 4 Feed Out Sensor #4
Tray 5 Feed Out Sensor #5
Jam at Tray n (Feed Out Sensor #4) Troubleshooting Procedure
Step Actions and Questions
1 Check paper condition.
Is the paper in the tray damaged?
2
Check paper size settings.
Does the paper size match the setting?
3 Remove the tray and check the rollers.
Is the Feed, Retard, or Nudger Roller
worn or contaminated with paper dust?
4 Check paper position at Door C.
Does the paper touch the Feed Out
Sensor?
5 Test Feed Out Sensor #4.
1. Open Door C.
2. Run the Service Diagnostics Tray 4
Feed Out Sensor test.
Does the sensor change state?
6 Check the Feed Out Sensor #4 connection.
Are P/J825, P/J842 and P/J548
connected?
7
Check continuity between the Feed Out
Sensor #4 and Tray 4-5 PWB.
Is there continuity on each wire
between P/J825 <=> P/J548?
8
Check for +5 V at Feed Out Sensor #4.
Is there +5 V across the sensor
connector's Pin 3 <=> ground?
9
Check connections between the Tray 4-5
PWB and Engine Logic Board.
Are P/J541 and P/J413 connected?
3-64
References
Print Engine P/J Engine Logic Board
(page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
1000-Sheet Feeder P/J Locator (page 5-5)
1000-Sheet Tray 4 & 5 Wiring (page 5-9)
PL20.4 Tray 4-5 Feeder (2/2) (page 4-10)
PL20.6 Tray 4-5 Drive and Electrical (page 4-16)
Yes
Replace the
paper.
Go to Step 3.
Clean or replace
the Rollers.
Remove the
paper.
Go to Step 9.
Go to Step 7.
Go to Step 8.
Replace Feed Out
Sensor #4
(page 3-21).
Go to Step 10.
Phaser 5500 Printer Service Manual
No
Go to Step 2.
Correct paper
size settings.
Go to Step 4.
Go to Step 5.
Go to Step 6.
Connect the
sensor.
Repair the wiring.
Go to Step 9
Connect P/J541
and P/J413.