Jam At F - F4-82 Gate Snr On - Fuji Xerox Phaser 5500 Service Manual

Static Jam at F or G (Stacker Upper Tray Exit Sensor) Troubleshooting Procedure
Step Actions and Questions
13
Check the Transport Motor resistance.
Is there some amount of resistance
across P8342-2/5(COM) and P8342-1/3/
4/6?
14 Check for +24 V to the Transport Motor.
Is there +24 V across J8304-16 <=>
ground and J8304-18 <=> ground on the
Finisher Main PWB?
15 Replace the Transport Motor.
Print a Test Print.
Does the error still occur?

Jam at F - F4-82 Gate SNR ON

Paper does not reach the Gate Sensor within the specified time.
Applicable Error Code
Jam at F - F4-82 Gate SNR ON
Jam at F (Transport Gate Sensor ON) Troubleshooting Reference
Applicable Parts
H-X'port Belts
H-X'port Pinch Rollers
Entrance Rollers
H-X'port Exit Sensor
H-X'port Harness
Finisher H-X'port PWB
Finisher Entrance Sensor
Main Sensor Harness
Finisher Main PWB
Transport Motor
Main Drive Harness
Transport Gate Sensor
Gate Sensor Harness
Error Messages, Codes, and Procedures
Yes
Go to Step 14.
Go to Step 15.
Replace the
Finisher Main
PWB
(page 3-248).
References
Phaser 5500 Printer Options Service Manual
Horizontal Transport P/J Locator (page 5-29)
Horizontal Transport Wiring (page 5-39)
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (1/2) Wiring (page 5-40)
Finisher Motors Wiring (page 5-42)
PL25.2 Horizontal Transport (1/2) (page 4-46)
PL25.3 Horizontal Transport (2/2) (page 4-48)
PL25.12 Finisher Transport (1/2) (page 4-66)
PL25.13 Finisher Transport (2/2) (page 4-68
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
No
Replace the
Transport Motor
(page 3-222).
Replace the
Finisher Main
PWB
(page 3-248).
Problem solved.
3-131