Staple Cartridge Is Low Or Missing - Staple Pin Misfeed - Fuji Xerox Phaser 5500 Service Manual

Stapler is Empty (Low Staple Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions
7 Check the Low Staple Sensor signal.
Does the voltage across P8308-14 <=>
P8308-15 on the Finisher Main PWB
change when the Staple Cartridge is
removed or replaced?
8
Replace the Stapler Assembly.
Does the error still occur?
9 Replace the Finisher Main PWB.
Does the error still occur?

Staple Cartridge is Low or Missing - Staple Pin Misfeed

The Self Priming Sensor in the Staple Cartridge indicates not ready.
Staple Cartridge Low or Missing (Self-Priming Senor) Troubleshooting Reference
Applicable Parts
Finisher Main PWB
Staple Harness
Stapler Assembly
Engine Logic Board.
Staple Cartridge Low or Missing (Self-Priming Senor) Troubleshooting Procedure
Step Actions and Questions
1 Test the Self Priming Sensor.
Run the Service Diagnostics Staple Head
Self Priming Sensor test.
Does the sensor state change when the
Staple Cartridge is removed or
replaced?
2 Check the Staple Cartridge for a staple
jam.
Is there a staple jam?
3 Cycle the printer power.
Does the error still occur?
3-226
Yes
Go to Step 8.
Go to Step 9.
Replace the
Engine Logic
Board
(page 8-89).
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Staple P/J Locator (page 5-30)
Finisher Stapler Wiring (page 5-45)
PL25.8 Finisher Staple (page 4-58)
PL25.14 Finisher Electrical (page 4-70)
Yes
Go to Step 11.
After removal, go
to Step 3.
Go to Step 4.
Phaser 5500 Printer Service Manual
No
Replace the
Finisher Main
PWB
(page 3-248).
Problem solved.
Problem solved.
No
Go to Step 2.
Go to Step 4.
Problem solved.