Jam At Tray 6 - C8-5 Hcf F/O Snr Static Jam - Fuji Xerox Phaser 5500 Service Manual

Jam at C (Feed Out Sensor #5) Troubleshooting Procedure (Continued)
Step Actions and Questions
5
Check continuity between 1000-Sheet
Feeder and Engine Logic Board.
Is there continuity on each wire
between P/J541 <=> P/J413?
6 Check for +5 V to the Feed Out Sensor #5.
Is there +5 V across P/J825-3 (+) <=>
ground?
7 Check +5 V to the Tray 4-5 PWB.
Is there +5 V across P/J548-1 (+) <=>
ground?

Jam at Tray 6 - C8-5 HCF F/O SNR Static Jam

Remaining paper in the Tray 6 Feed Out Sensor #6, located in the Lower Feeder
Assembly under Door J.
Applicable Error Code
Jam at Tray 6 - C8-5 HCF F/O SNR Static Jam
Jam at Tray 6 (Feed Out Sensor #6) Troubleshooting Reference
Applicable Parts
Feed Roller
Retard Roller
Take Away Roller
Door J
Pre-Feed Sensor
Feed Out Sensor #6
Feeder Harness
Main Harness
Take Away Motor
Feeder Motor
Tray 6 PWB
Engine Logic Board)
Error Messages, Codes, and Procedures
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
2000-Sheet Tray 6 Feeder P/J (page 5-20)
2000-Sheet Tray 6 Drive P/J (page 5-21)
2000-Sheet Tray 6 Sensors Wiring (page 5-24)
2000-Sheet Tray 6 Drive Wiring (page 5-25)
PL22.4 Tray 6 Feeder (1/3) (page 4-24)
PL22.5 Tray 6 Feeder (2/3) (page 4-26)
PL22.6 Tray 6 Feeder (3/3) (page 4-28)
PL22.7 Drive and Transportation (page 4-30)
PL22.8 Tray 6 Electrical (page 4-32)
Yes
Go to Step 6.
Replace the Feed
Out Sensor #5
(page 3-22).
Replace the Tray
4-5 PWB
(page 3-29).
No
Repair the wiring.
Go to Step 7.
Replace the
Engine Logic
Board
(page 8-89).
3-79