Punch Failure - H5-3N Home Snr - Fuji Xerox Phaser 5500 Service Manual

Punch Failure (Punch Home Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions
10 Check the harness connections.
Are P/J8345 and P/J8332 on the Punch
Harness, and P/J8332 and P/J8306 on
the Punch Drive Harness connected?
11 Print a Test Print.
Does the error still occur?
12 Check Punch Motor Harness continuity.
1. Disconnect P/J8345 and P/J8332.
2. Check for continuity at the following:
P/J8345-2 <=> P/J8332-2
P/J8345-1 <=> P/J8332-1
Are these conductive?
13 Check Punch Motor Drive Harness
continuity.
1. Disconnect P/J8332 and P/J8306.
2. Check for continuity at the following:
P/J8332-2 <=> P/J8306-8
P/J8332-1 <=> P/J8306-7
Are these conductive?
14
Replace the Punch Motor.
Punch a Test Print.
Does the error still occur?

Punch Failure - H5-3n Home SNR

The Punch Unit Move Home Sensor does not change state within the specified time
following activation of the Punch Move Motor or the Move Home sensor changes
state after the Punch Move Motor has stopped.
Applicable Error Codes
Punch Failure - H5-33 Home SNR ON
Punch Failure - H5-34 Home SNR OFF
3-174
Yes
Go to Step 12.
Go to Step 12.
Go to Step 13.
Go to Step 14.
Replace the
Finisher Main
PWB
(page 3-248).
Phaser 5500 Printer Service Manual
No
Connect and go
to Step 11.
Problem solved.
Repair the Punch
Harness.
Repair the Punch
Motor Drive
Harness.
Problem solved.