Jam At G - F4-4N Buffer Path Snr Static - Fuji Xerox Phaser 5500 Service Manual

Jam at G (Buffer Path Sensor ON) Troubleshooting Procedure (Continued)
Step Actions and Questions
44 Print a Test Print.
Does the error still occur?
45 Check Buffer Sensor Harness continuity.
1. Disconnect P/J8392 and P/J8318B.
2. Check for continuity at the following:
J8392-3 <=> J8318B-1
J8392-2 <=> J8318B-2
J8392-1 <=> J8318B-3
Are these conductive?
46 Check Main Sensor Harness continuity.
1. Disconnect P/J8318A from the harness,
and P/J8302A on the Finisher Main
PWB.
2. Check for continuity at the following:
J8318A-3 <=> J8302A-13
J8318A-2 <=> J8302A-14
J8318A-1 <=> J8302A-15
Are these conductive?
47 Check for +5 V to the Buffer Path Sensor.
Is there +5 V across J8302A-15 <=>
J8302A-13 on the Finisher Main PWB?
48 Check Buffer Path Sensor signal.
Does the voltage across P8302A-14 <=>
P8302A-13 on the Finisher Main PWB
change when the actuator is operated?

Jam at G - F4-4n Buffer Path SNR Static

Remaining paper is detected in the Buffer Path by the Buffer Path Sensor.
Applicable Error Codes
Jam at G - F4-46 Buffer Path SNR Static Jam A
Jam at G - F4-47 Buffer Path SNR Static Jam B
Jam at G - F4-48 Buffer Path SNR Static Jam C
3-106
Yes
Go to Step 45.
Go to Step 46.
Go to Step 47.
Go to Step 48.
Replace the
Finisher Main
PWB
(page 3-248).
Phaser 5500 Printer Service Manual
No
Problem solved.
Repair the Buffer
Sensor Harness.
Repair the Main
Sensor Harness.
Replace the
Finisher Main
PWB
(page 3-248).
Replace the
Buffer Path
Sensor
(page 3-207).