Fuji Xerox Phaser 5500 Service Manual page 460

5. Remove the two tapping screws securing the Chute-R to the Registration
Transport Assembly to remove the Chute-R.
6. Remove the Pinch Roller in the center of the Registration Transport Assembly to
provide access to the locking retaining tab behind the Registration Transport
Assembly.
7. Remove the two screws securing the Registration Transport Assembly to the
frame.
8. Using a small screwdriver, or something similar, push on the retaining tab to
unlock it from the notch in the frame while pushing the Registration Transport
Assembly to the left, and lifting the center upward to release the retaining tab
from the frame. Extract the Registration Transport Assembly from the frame by
moving it in the direction of the arrow. Use care to avoid damage to the wiring
connected on the back.
Note
It could require significant force to flex the Registration Transport Assembly to
clear the retaining tab and remove it from the frame.
9. Release the harness from the clamp.
10.
Disconnect the connector from the Registration Trans Assembly.
11. Disconnect the connector from the printer.
Replacement Note
Make sure the retaining tab fits over the frame rather than under it.
8-50 Phaser 5500 Printer Service Manual