Fuji Xerox Phaser 5500 Service Manual page 133

C6-2 Duplex Area Jam Troubleshooting Procedure (Continued)
Step Actions and Questions
8
Test the Wait Sensor.
Run the Service Diagnostics Duplex Wait
Sensor test.
Does the Wait Sensor operate properly?
9 Check the Wait Sensor connection.
Are P/J123 and P/J541 connected?
10 Check continuity between the Wait Sensor
and Duplex PWB.
Is there continuity on each wire
between P/J123 <=> P/J541?
11 Check for +5 V to the Wait Sensor.
Is there +5 V across P123-3 (+) <=>
ground?
12 Check continuity between the Duplex PWB
and Engine Logic Board.
Is there continuity on each wire
between P/J540 <=> P/J417?
13 Check for +5 V to the Duplex PWB.
Is there +5 V across P/J540-1 (+) <=>
ground?
14 Test the Duplex Motor.
Run the Service Diagnostics Duplex Motor
test.
Does the Duplex Motor operate
properly?
15 Check the Duplex Motor for connection.
Are P/J212 and P/J542 connected?
16 Check the Duplex Motor for continuity.
Is there continuity on each wire
between P/J212 <=> P/J542?
17
Check for +24 V to the Duplex Motor.
Is the +24 V across P/J212-5 (+) <=>
ground?
18 Check the Duplex PWB connection.
Are P/J540 and P/J417 connected?
19 Check continuity between the Duplex PWB
and Engine Logic Board.
Is there continuity on each wire
between P/J540 <=> P/J417?
20 Check for +5 V to the Duplex PWB.
Is there +5 V across P/J540-1 (+) <=>
ground?
Error Messages, Codes, and Procedures
Yes
Go to Step 14.
Go to Step 10.
Go to Step 11.
Replace the Wait
Sensor
(page 3-78).
Go to Step 13.
Replace the
Duplex PWB
(page 3-77).
Go to Step 21.
Go to Step 16.
Go to Step 17.
Replace the
Duplex Motor
(page 3-76).
Go to Step 19.
Go to Step 20.
Replace the
Duplex PWB
(page 3-77).
No
Go to Step 9.
Connect P/J123
and P/J541.
Repair the wiring.
Go to Step 12.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 15.
Connect P/J212
and P/J542.
Repair the wiring.
Go to Step 18.
Connect P/J540
and P/J417.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
3-55