Jam At B - C8-2 F/O3 Snr Static Jam - Fuji Xerox Phaser 5500 Service Manual

Jam at B - C8-2 F/O3 SNR Static Jam

Paper remains at Feed Out Sensor #3 located behind Door B.
Applicable Error Code
Jam at B - C8-2 F/O3 SNR Static Jam
Jam at B (Feed Out #3 Sensor) Troubleshooting Reference
Applicable Parts
Feed Out Sensor #3
Tray 3 Feed/Lift Motor
Engine Logic Board
Jam at B (Feed Out #3 Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Check the paper path.
Open Door B.
Does the paper touch the Tray 3 Feed
Out Sensor?
2 Test the Feed Out Sensor #3.
1. Open Door B.
2. Run the Service Diagnostics Tray 3
Feed Out Sensor test.
Does the sensor change state?
3 Check the sensor connection.
Are P/J105, P/J608, and P/J410
connected?
4
Check continuity between the sensor and
Engine Logic Board.
Is there continuity on each wire
between P/J105 <=> P/J410?
5 Check for +5 V to the Feed Out Sensor #3.
Is there +5 V across P105-1(+)<=>
ground?
3-76
References
Print Engine P/J Tray 2 & 3 Feeder (page 10-11)
Print Engine Registration Transport Wiring
(page 10-23)
PL2.3 Feeder (2/2) (page 9-12)
PL4.5 Registration (page 9-30)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Service Manual
Yes
Remove the
paper.
Replace the
Engine Logic
Board (8-89).
Go to Step 4.
Go to Step 5.
Replace the Feed
Out Sensor #3
(page 8-54).
No
Go to Step 2.
Go to Step 3.
Connect the
sensor.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).