Test Print Menu; Printer Nvram Adjustments Menu - Fuji Xerox Phaser 5500 Service Manual

Test Print Menu

Use Test Print options to identify, repair, and validate the operability of xerographics
and paper handling from all paper sources, options and outputs. Configure your test
using the options provided. Service Diagnostics generates an error for failures that
occur during these tests. If multiple faults/jams are detected, only one error message
appears at a time. The next message appears when the current fault is cleared.
Test Print Utilities
Utility
Print Pattern
Print Quantity
Input Tray
Output Tray
Duplex
Staple Selection
Pages Per Set
Punch Selection
Select Pattern

Printer NVRAM Adjustments Menu

Registration variables are stored in NVRAM to manage image registration for the
scan and process directions on paper supplied from each input tray for simplex or
duplex operations. This allows for the correction of minor variations as a result of
wear or mis-alignment. When making adjustments for scan direction, or for all trays
in the process direction, adjustment changes are automatically replicated for duplex
prints. Following a scan or all tray process direction adjustment, check that duplex
registration remains within specification. See "Checking Registration" on page 6-4
for detailed instructions for using these utilities to adjust image registration.
For convenience, similar registration adjustment utilities have been grouped together
in the following table. However, all 19 adjustments appear on the Service Diagnostics
Menu Map on page A-4.
A-10
Action/Requirement
Print one of the stored Engine test pages: Grid, Chart, Dark Dusting
or Blank. Start or Stop printing tests.
Select the number of test prints to run. Select a quantity of two or
more when the Stacker Lower Tray is the selected output tray. If
Duplex is set to On, the quantity selected indicates the number of
two-sided prints.
Sets the input tray. Printing is disabled in Diagnostic mode if
Tray 1/MPT is the selected input tray and the output is set anything
other than the Standard Output Tray.
Sets the output tray. Test prints fed from Tray 1/MPT output to the
Standard Output Tray only.
Turns Duplex printing on or off. Test prints fed from Tray 1/MPT do
not Duplex as Tray 1/MPT is set to irregular size in Diagnostic mode.
Sets staple on or off and displays the currents staple position setting
(Dual, Front, or Rear).
Sets the number of pages per stapled set.
Sets punch on or off.
Select the number of holes to be punched.
Phaser 5500 Printer Service Manual