Stacker Lower Tray Failure - Fuji Xerox Phaser 5500 Service Manual

Staple Set Over Count Troubleshooting Procedure (Continued)
Step Actions and Questions
2 Cycle the printer power.
Does the error still occur?
3 Replace the Finisher Main PWB.
Does the error still occur?

Stacker Lower Tray Failure

The Stacker No Paper Sensor does not change state within the time specified
following the Stacker Lower Tray beginning to lower.
Lower Tray Failure (No Paper Sensor) Troubleshooting Reference
Applicable Parts
Finisher Main PWB
Sensor Actuator
Stacker No Paper
Sensor
Main Sensor
Harness
Elevator Motor
Engine Logic
Board.
Lower Tray Failure (No Paper Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Check the lower part of the Stacker for
obstacles.
Are there any obstacles on the lower
part of the Stacker Tray?
2
Check the Actuator installation.
Does the Actuator enter the Upper Limit
sensor sensing area?
3 Check the Stacker No Paper Sensor.
Run the Service Diagnostics Stacker No
Paper Sensor test.
Does the sensor state change when the
sensor is blocked?
3-230
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (2/2) Wiring (page 5-41)
Finisher Clutch and Solenoids (page 5-43)
PL25.6 Finisher Stack (page 4-54)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Phaser 5500 Printer Service Manual
Yes
Go to Step 3.
Replace the
Engine Logic
Board
(page 8-89).
Yes
Remove any
obstacles.
Repair the
Actuator.
Go to Step 9.
No
Problem solved.
Problem solved.
No
Go to Step 2.
Go to Step 3.
Go to Step 4.