Jam At F Or G - F4-7N Top Tray Exit Snr Static - Fuji Xerox Phaser 5500 Service Manual

Jam at F or G - F4-7n Top Tray Exit SNR Static

Paper is detected by the Stacker Upper Tray Exit Sensor.
Applicable Error Codes
Jam at F - F4-76 Top Tray Exit SNR Static
Jam at G - F4-77 Top Tray Exit SNR Static
Jam at G - F4-78 Top Tray Exit SNR Static
Static Jam at F or G (Stacker Upper Tray Exit Sensor) Troubleshooting Reference
Applicable Parts
Transport Motor
Main Drive Harness
Finisher Main PWB
Top Exit Sensor Harness
Main Sensor Harness
Upper Tray Exit Sensor
Static Jam at F or G (Stacker Upper Tray Exit Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Test the Upper Tray Exit Sensor.
Run the Service Diagnostics Upper Tray
Exit Sensor test.
Does the sensor state change?
2
Check the Upper Tray Exit Sensor Harness
connections.
Are P/J8321 and P/J8312 on the sensor
harness, and P/J8312 and P/J8302 on
the Main Sensor Harness connected?
3
Print a Test Print.
Does the error still occur?
4 Check Upper Tray Exit Sensor Harness
continuity.
1. Disconnect P/J8321 and P/J8312.
2. Check for continuity at the following:
P/J8321-3 <=> J8312B-1
P/J8321-2 <=> J8312B-2
P/J8321-1 <=> J8312B-3
Are these conductive?
Error Messages, Codes, and Procedures
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (1/2) Wiring (page 5-40)
Finisher Motors Wiring (page 5-42)
PL25.12 Finisher Transport (1/2) (page 4-66)
PL25.13 Finisher Transport (2/2) (page 4-68
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Yes
Go to Step 8.
Go to Step 4.
Go to Step 4.
Go to Step 5.
No
Go to Step 2.
Connect and go
to Step 3.
Problem solved.
Repair the Top
Tray Exit Sensor
Harness.
3-129