Jam At A - E4-1 Exit 2 Area Jam - Fuji Xerox Phaser 5500 Service Manual

Jam at A - E4-1 Exit 2 Area Jam

Paper did not reach the Exit 2 Exit Sensor located behind Door E on time.
Applicable Error Code
Jam at A - E4-1 Exit 2 Area Jam
E4-1 Exit 2 Area Jam Troubleshooting Reference
Applicable Parts
Fuser Exit Sensor
Exit 2 Exit Sensor
Exit 1 OCT Roller
Exit 1 Motor
Exit PWB
Engine Logic Board
LVPS
E4-1 Exit 2 Area Jam Troubleshooting Procedure
Step Actions and Questions
1 Check paper position at Door A.
Is paper touching the Fuser Exit
Sensor?
2 Check paper position at Door E.
Is paper touching the Exit Sensor?
3 Check the OCT Roller.
Is the OCT Roller worn or contaminated
with paper dust?
4 Check the drive transmission.
Does the OCT Roller and gears rotate
smoothly?
5
Test the Fuser Exit Sensor.
1. Open Door A.
2. Run the Service Diagnostics Fuser Exit
Sensor test.
Does the sensor change state?
6 Check the Fuser Exit Sensor connection.
Are P/J125 and P/J410 connected?
7 Check continuity between the Fuser Exit
Sensor and Engine Logic Board.
Is there continuity on each wire
between P/J125 <=> P/J410?
3-42
References
Print Engine P/J Fuser and Exit 1 (page 10-8)
Print Engine Fuser Wiring (page 10-22)
Exit 2 Plug/Jack Locator (page 5-15)
Exit 2 Sensor/Fan Wiring(page 5-18)
PL6.1 Fuser and Exit 1 (page 9-34)
PL8.1 Print Engine Electrical (page 9-40)
PL24.2 Exit 2 Tray Guide Assembly (page 4-40)
Phaser 5500 Printer Service Manual
Yes
Remove the
paper.
Remove the
paper.
Clean or replace
the OCT Roller.
Go to Step 5.
Go to Step 9.
Go to Step 7.
Go to Step 8.
No
Go to Step 2.
Go to Step 3.
Go to Step 4.
Restore proper
operation.
Go to Step 6.
Connect the
sensor.
Repair the wiring.