Fuji Xerox Phaser 5500 Service Manual page 114

Paper Size Jam (Registration Sensor) Troubleshooting Reference
Applicable Parts
Registration Sensor
Registration Clutch
Take Away Roller
Engine Logic Board
Paper Size Jam (Registration Sensor) Troubleshooting Procedure
Step Actions and Questions
1
Check paper position at Door A or B.
Does the paper touch the Registration
Sensor or Feeder's Pre-Feed Sensor?
2
Check the Take Away Roller.
Open Door A.
Is the Take Away Roller worn or
contaminated with paper dust?
3 Test the Registration Sensor.
1. Open Door A.
2. Run the Service Diagnostics
Registration Sensor test.
Does the sensor change state?
4 Check the Registration Sensor connection.
Are P/J104 and P/J403B connected?
5 Check continuity between the Registration
Sensor and Engine Logic Board.
Is there continuity on each wire
between P/J104 <=> P/J403?
6 Check for +5 V at the Registration Sensor.
Is there +5 V across the sensor
connector's P/J104-1 <=> ground?
7 Test the Registration Clutch operation.
Run the Service Diagnostics Registration
Clutch test.
Does the clutch operate properly?
8 Check the Registration Clutch connection.
Are P/J215 and P/J403B connected?
9
Check continuity between the Registration
Clutch and Engine Logic Board.
Is there continuity on each wire
between P/J215 <=> P/J403?
3-36
References
Print Engine P/J Registration Transport (page 10-10)
Print Engine Registration Transport Wiring
(page 10-23)
PL4.1 Transportation and Registration (page 9-22)
PL4.5 Registration (page 9-30)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Service Manual
Yes
Remove the
paper.
Clean or replace
the Take Away
Roller.
Go to Step 7.
Go to Step 5.
Go to Step 6.
Replace the
Registration
Sensor
(page 8-52).
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 9.
Go to Step 10.
No
Go to Step 2.
Go to Step 3.
Go to Step 4.
Connect the
sensor.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 8.
Connect P/J215
and P/J403B.
Repair the wiring.