Jam At D And A - C6-1 Duplex Area Jam - Fuji Xerox Phaser 5500 Service Manual

E8-2 Duplex Area Jam Troubleshooting Procedure (Continued)
Step Actions and Questions
17
Test the Wait Sensor.
Run the Service Diagnostics Duplex Wait
Sensor test.
Does the Wait Sensor operate properly?
18 Check the Wait Sensor connection.
Are P/J123 and P/J541 connected?
19 Check continuity between the Wait Sensor
and Duplex PWB.
Is there continuity on each wire
between P/J123 <=> P/J541?
20 Check for +5 V to the Wait Sensor.
Is there +5 V across P123-3 (+) <=>
ground?
21 Check the Duplex PWB connection.
Are P/J540 and P/J417 connected?
22 Check continuity between the Duplex PWB
and Engine Logic Board.
Is there continuity on each wire
between P/J540 <=> P/J417?
23 Check for +5 V to the Duplex PWB.
Is there +5 V across P/J540-1 (+) <=>
ground?

Jam at D and A - C6-1 Duplex Area Jam

Paper being fed from the Duplex Unit did not reach the Registration Sensor, located
behind Door A, on time.
Applicable Error Code
Jam at D and A - C6-1 Duplex Area Jam
Error Messages, Codes, and Procedures
Yes
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 19.
Go to Step 20.
Replace the Wait
Sensor
(page 3-78).
Go to Step 22.
Go to Step 23.
Replace the
Duplex PWB
(page 3-77).
No
Go to Step 18.
Connect P/J123
and P/J541.
Repair the wiring.
Go to Step 21.
Connect P/J540
and P/J417
surely.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
3-51