Stacker Lower Tray Failure - H5-13 Low Tray Lower Limit - Fuji Xerox Phaser 5500 Service Manual

Stacker Lower Tray Failure - H5-13 Low Tray Lower
Limit
The Stacker Lower Tray descends beyond the specified lower limit position.
Applicable Error Code

Stacker Lower Tray Failure - H5-13 Low Tray Lower Limit

Stacker Lower Trail Failure (Stacker Encoder Sensor) Troubleshooting Reference
Applicable Parts
Stack Height Sensor 1
Stack Height Sensor 2
Stacker Encoder
Sensor
Finisher Main PWB
Main Sensor Harness
Elevator Motor
Stacker Lower Trail Failure (Stacker Encoder Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Check the Stacker Lower Tray vertical
transport and belts for obstacles and
deformation.
Are there obstacles or belt wear in the
vertical transport mechanism?
2 Test the Stack Height Sensor 1 (top).
Run the Service Diagnostics Stack Height
1 test.
Does the sensor state change when the
sensor is blocked?
NOTE: Sensor requires a 10 second
timeout between sensing events.
3 Check Stack Height Sensor 1 Sensor
Harness connection.
Are P/J8331 and P/J8302B connected?
4 Print a Test Print.
Does the error still occur?
Error Messages, Codes, and Procedures
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (2/2) Wiring (page 5-41)
Finisher Clutch and Solenoids (page 5-43)
PL25.6 Finisher Stack (page 4-54)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Yes
Remove any
obstacles.
Go to Step 8.
Go to Step 5.
Go to Step 5.
No
Go to Step 2.
Go to Step 3.
Connect and go
to Step 4.
Problem solved.
3-165