Finisher Board Failure - H5-4, 7, 8 Nvm/Comm/Type Error - Fuji Xerox Phaser 5500 Service Manual

Paper Size Failure (Tray 4-5 Paper Size Switch) Troubleshooting Procedure
Step Actions and Questions
10
Check for +5 V to the Tray 4-5 PWB
Is there +5 V across P/J413-A5 (+) <=>
ground?
Finisher Board Failure - H5-4, 7, 8 NVM/Comm/Type
Error
Applicable Error Codes
Finisher Board Failure - H5-4 NVM R/W Error
Finisher Failure - H5-7 MCU-Finisher Comm Error
Incorrect Finisher Installed - H5-8 Finisher Type Error
Finisher Board Error (NVRAM R/W Error) Troubleshooting Reference
Applicable Parts
Finisher Main PWB
Engine Logic
Board
Finisher Board Error (NVRAM R/W Error) Troubleshooting Procedure
Step Actions and Questions
1 Check the Finisher installation.
Are the interface cables connected
correctly?
2 Does the error occur when the power is
cycled?
3 Check Finisher Main PWB connections.
Are P/J8300 and P416 connected?
Error Messages, Codes, and Procedures
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
PL25.14 Finisher Electrical (page 4-70)
Yes
Replace the
Tray 4-5 PWB
(page 3-29).
Yes
Go to Step 2.
Go to Step 2.
Go to Step 3.
No
Replace the
Engine Logic
Board
(page 8-89).
No
Reconnect the
cables and got to
Step 2.
Problem solved.
Connect all
connectors. Go to
Step 3.
3-159