Fuji Xerox Phaser 5500 Service Manual page 185

Jam at G (Buffer Path Sensor Static) Troubleshooting Reference
Applicable Parts
Buffer Path Sensor
Buffer Sensor Harness
Main Sensor Harness
Finisher Main PWB
Main Drive Harness
Registration Motor
Jam at G (Buffer Path Sensor Static) Troubleshooting Procedure
Step Actions and Questions
1 Test the Buffer Path Sensor.
Run the Service Diagnostics Buffer Path
Sensor test.
Does the sensor state change?
2 Check the Buffer Path Sensor connection.
Are P/J8392 and P/J8318 connected?
3
Print a Test Print.
Does the error still occur?
4
Check Main Sensor Harness connections.
Are P/J8318A and P/J8302 connected?
5 Print a Test Print.
Does the error still occur?
6 Check Buffer Sensor Harness continuity.
1. Disconnect P/J8392 and P/J8318.
2. Check for continuity at the following:
P/J8392-3 <=> J8318B-1
P/J8392-2 <=> J8318B-2
P/J8392-1 <=> J8318B-3
Are these conductive?
7 Check Main Sensor Harness continuity.
1. Disconnect P/J8318 from the harness,
and P/J8302A on the Finisher Main
PWB.
2. Check for continuity at the following:
J8318A-3 <=> P/J8302A-13
J8318A-2 <=> P/J8302A-14
J8318A-1 <=> P/J8302A-15
Are these conductive?
Error Messages, Codes, and Procedures
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (1/2) Wiring (page 5-40)
Finisher Motors Wiring (page 5-42)
PL25.12 Finisher Transport (1/2) (page 4-66)
PL25.13 Finisher Transport (2/2) (page 4-68)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Yes
Go to Step 10.
Go to Step 4.
Go to Step 4.
Go to Step 6.
Go to Step 6.
Go to Step 7.
Go to Step 8.
No
Go to Step 2.
Connect and go
to Step 3.
Problem solved.
Connect and go
to Step 5.
Problem solved.
Repair the Buffer
Sensor Harness.
Repair the Main
Sensor Harness.
3-107