Exit Unit Failure - H3-N Offset Error - Fuji Xerox Phaser 5500 Service Manual

Incorrect Duplex Unit Installed Troubleshooting Procedure (Continued)
Step Actions and Questions
2 Check for +24 V to the Duplex PWB.
Is there +24 V across P/J540-2 (+) <=>
ground?

Exit Unit Failure - H3-n Offset Error

Failure to establish Offset Home Position on Exit1 (H3-1) or Exit 2 (H3-2).
Applicable Error Codes
Exit Unit Failure - H3-1 Offset Error
Exit Unit Failure - H3-2 Offset Error
Exit Offset Error (OCT Position Sensor) Troubleshooting Reference
Applicable Parts
OCT Position
Sensor
Offset Motor
Exit PWB
LVPS
Engine Logic
Board
Exit Offset Error (OCT Position Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Test the affected OCT Position Sensor.
Run the Service Diagnostics Exit 1 or 2
Offset Home Position Sensor test.
Does the sensor state change?
2 Check the sensor connection.
Is P/J117 (Exit 1) or P/J111 (Exit 2)
connected?
3 Check continuity between the affected
OCT Position Sensor and the Exit PWB P/
J111 <=> P/J434 and SJ1 (Exit2) P/J117
<=> P/J423 (Exit 1).
Is there continuity on each wire?
3-150
References
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine P/J Laser and Exit PWB (page 10-7)
Print Engine LVPS Wiring (page 10-21)
Print Engine Exit 1 Wiring (page 10-30)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
Exit 2 Plug/Jack Locator (page 5-15)
Exit 2 General Wiring (page 5-7)
PL24.2 Exit 2 Tray Guide Assembly (page 4-40)
Phaser 5500 Printer Service Manual
Yes
Replace the
Duplex PWB
(page 3-77).
Yes
Go to Step 10.
Go to Step 3.
Go to Step 4.
No
Replace the
Engine Logic
Board
(page 8-89).
No
Go to Step 2.
Connect the
sensor.
Repair the wiring.