Jam At F Or G - Gate Snr Static Jam (Lower Tray) - Fuji Xerox Phaser 5500 Service Manual

Jam at F or G - Gate SNR Static Jam (Lower Tray)

Paper remains at the Gate Sensor when the Finisher is in the Stacker Lower Tray exit
mode.
Applicable Error Codes
Jam at F - F4-86 Gate SNR Static Jam A
Jam at G - F4-87 Gate SNR Static Jam B
Jam at G - F4-88 Gate SNR Static Jam C
Static Jam at F or G (Gate Sensor) Troubleshooting Reference
Applicable Parts
Transport Motor
Main Drive Harness
Finisher Main PWB
Top Exit Sensor Harness
Gate Sensor
Gate Sensor Harness
Transport Gate Solenoid
Static Jam at F or G (Gate Sensor) Troubleshooting Procedure
Step Actions and Questions
1
Test the Finisher Transport Motor.
Run the Service Diagnostics Finisher
Transport Motor Test.
Does the motor rotate normally?
2 Test Entrance and Transport Roller drive.
Run the Service Diagnostics Finisher
Transport Motor Test.
Do the Entrance and Transport Rollers
rotate?
3
Check the Transport Motor Drive Harness.
Are P/J8342 and P/J8304 connected?
4 Print a Test Print.
Does the error still occur?
3-138
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Motors Wiring (page 5-42)
Finisher Clutch and Solenoids (page 5-43)
PL25.12 Finisher Transport (1/2) (page 4-66)
PL25.13 Finisher Transport (2/2) (page 4-68)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Yes
Go to Step 2.
Go to Step 9.
Go to Step 5.
Go to Step 5.
Phaser 5500 Printer Service Manual
No
Go to Step 3.
Restore operation
and go to Step 4.
Connect and go
to Step 4.
Problem solved.