Toner Empty- J1-2 Toner Empty - Fuji Xerox Phaser 5500 Service Manual

Tray Failure (Tray 4-5 Paper Size Switch) Troubleshooting Procedure (Continued)
Step Actions and Questions
9
Check for +5 V to the Tray 4-5 PWB
Is there +5 V across P/J413-A5 (+) <=>
ground?
10 Check the Paper Size Switch connection.
For Tray 4:
Are P/J820 and P/J548 connected?
For Tray 5:
Are P/J824 and P/J548 connected?

Toner Empty- J1-2 Toner Empty

The Toner Cartridge is empty.
Applicable Error Code
Toner Empty - J1-2 Toner Empty
Toner Empty Troubleshooting Reference
Applicable Parts
Toner Cartridge
Toner Dispense
Assembly
Toner Dispense Motor
Toner CRUM PWB
Engine Logic Board
Toner Empty Troubleshooting Procedure
Step Actions and Questions
1 Check remaining toner.
Does the Toner Cartridge contain
sufficient toner?
2 Check the Toner Cartridge installation.
Remove the Toner Cartridge and reinstall.
Does it operate properly?
3
Check the gear of the Toner Dispense
Assembly.
Does the gear of the Toner Dispense
Assembly rotate smoothly?
Error Messages, Codes, and Procedures
References
Print Engine P/J Drum and Toner (page 10-6)
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine Xerographics Wiring (page 10-24)
Print Engine Drive/CRUM Wiring (page 10-25)
PL5.1 Laser, CRU and Toner Dispense (page 9-32)
PL8.1 Print Engine Electrical (page 9-40)
Yes
Replace the Tray
4-5 PWB
(page 3-29).
Go to Step 6.
Yes
Go to Step 2.
Problem solved.
Go to Step 4.
No
Replace the
Engine Logic
Board
(page 8-89).
Connect the
Paper Size
Switch.
No
Replace the
Toner Cartridge.
Go to Step 3.
Restore proper
operation.
3-197