Jam At A Or F - F4-N H-X'port Ent. Snr Static - Fuji Xerox Phaser 5500 Service Manual

Jam at A (H-X'port Entrance Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions
14
Replace the H-'Xport Motor.
Print a Test Print.
Does the error still occur?
15 Replace the H-'Xport PWB.
Print a Test Print.
Does the error still occur?

Jam at A or F - F4-n H-X'port Ent. SNR Static

The paper did not exit the Horizontal Transport on time.
Applicable Error Codes
Jam at A - F4-16 H-X'port Ent. SNR Static Jam A
Jam at F - F4-17 H-X'port Ent. SNR Static Jam B
Jam at A or F (H-X'port Entrance Sensor) Troubleshooting Reference
Applicable Parts
H-X'port Motor
H-X'port Harness
H-X'port Entrance
Sensor
Finisher H-X'port PWB
Jam at A or F (H-X'port Entrance Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Test the H-'Xport Entrance Sensor.
1. Open Door F.
2. Run the Service Diagnostic H-'Xport
Entrance Sensor test.
Does the sensor change state?
2
Check the H-'Xport Harness connections.
Is the harness connected to the H-
X'port Entrance Sensor and Finisher
correctly?
Error Messages, Codes, and Procedures
Yes
Go to Step 15.
Replace the
Finisher Main
PWB
(page 3-248).
References
Phaser 5500 Printer Options Service Manual
Horizontal Transport P/J Locator (page 5-29)
Horizontal Transport Wiring (page 5-39)
Finisher Main PWB P/J Locator (page 5-35)
PL25.2 Horizontal Transport (1/2) (page 4-46)
PL25.3 Horizontal Transport (2/2) (page 4-48)
PL25.14 Finisher Electrical (page 4-70)
Yes
Go to Step 7.
Go to Step 4.
No
Problem solved.
Problem solved.
No
Go to Step 2.
Reconnect and
go to Step 3.
3-89