Stacker Lower Tray Failure - H5-8N Set Clamp Snr - Fuji Xerox Phaser 5500 Service Manual

Eject Clamp Failure (Eject Clamp Home Sensor) Troubleshooting Procedure
Step Actions and Questions
8 Test the Eject Clamp Motor.
Run the Service Diagnostics Up and Down
Eject Clamp Motor tests.
Does the Eject Clamp Motor rotate
normally?
9
Check Eject Clamp Motor Harness
connections.
Are P/J8339 and P/J8304 connected?
10 Print a Test Print.
Does the error still occur?
11 Check Eject Clamp Motor Harness
continuity.
1. Disconnect P/J8339 and P/J8304.
2. Check for continuity at the following:
P/J8339-1 <=> P/J8304-33
P/J8339-2 <=> P/J8304-31
Are these conductive?
12 Check Eject Clamp Motor voltage.
Is there +24 V across P/J8304-31 and -33
<=> P/J8302A-1?
13 Replace the Eject Clamp Motor.
Print a Test Print.
Does the error still occur?

Stacker Lower Tray Failure - H5-8n Set Clamp SNR

The Set Clamp Home Sensor does not change state within the time interval specified
following the start or stop of the Set Clamp.
Applicable Error Codes
Stacker Lower Tray Failure - H5-83 Set Clamp SNR ON
Stacker Lower Tray Failure - H5-84 Set Clamp SNR OFF
3-178
Yes
Replace the
Finisher Main
PWB
(page 3-248).
Go to Step 11.
Go to Step 11.
Go to Step 12.
Go to Step 13.
Replace the
Finisher Main
PWB
(page 3-248).
Phaser 5500 Printer Service Manual
No
Go to Step 9.
Connect and go
to Step 10.
Problem solved.
Repair the Eject
Clamp Motor
Harness.
Replace the
Finisher Main
PWB
(page 3-248).
Problem solved.