Stacker Lower Tray Failure - H5-8N Eject Clamp Snr - Fuji Xerox Phaser 5500 Service Manual

Punch Failure (Punch Move Home Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions
8 Test the Punch Move Motor.
Run the Service Diagnostics Front and
Rear Punch Move Motor tests.
Does the Punch Move Motor rotate and
the Punch frame move?
9
Check Punch Motor Harness connections.
Are P/J8344 and P/J8306 connected?
10 Print a Test Print.
Does the error still occur?
11 Check Punch Motor Harness continuity.
1. Disconnect P/J8344 and P/J8306.
2. Check for continuity at the following:
P/J8344-1 <=> P/J8306-7
P/J8344-2 <=> P/J8306-3
P/J8344-3 <=> P/J8306-6
P/J8344-4 <=> P/J8306-5
P/J8344-5 <=> P/J8306-2
P/J8344-6 <=> P/J8306-1
Are these conductive?
12 Replace the Punch Move Motor.
Punch a Test Print.
Does the error still occur?
13 Replace the Finisher Main PWB.
Does the error still occur?

Stacker Lower Tray Failure - H5-8n Eject Clamp SNR

The Eject Clamp Home Sensor does not change state within the time interval
specified following the activation of the Eject Clamp.
Applicable Error Codes
Stacker Lower Tray Failure - H5-81 Eject Clamp SNR ON
Stacker Lower Tray Failure - H5-82 Eject Clamp SNR OFF
3-176
Yes
Replace the
Finisher Main
PWB
(page 3-248).
Go to Step 11.
Go to Step 11.
Go to Step 12.
Go to Step 13.
Replace the
Finisher Main
PWB
(page 3-248).
Phaser 5500 Printer Service Manual
No
Go to Step 9.
Connect and go
to Step 10.
Problem solved.
Repair the Punch
Motor Harness.
Problem solved.
Problem solved.