Jam At H - F4-56 Compile Exit Snr Static - Fuji Xerox Phaser 5500 Service Manual

Jam at F or G (Compile Exit Sensor ON) Troubleshooting Procedure (Continued)
Step Actions and Questions
26
Check Main Sensor Harness continuity.
1. Disconnect P/J8391 from the harness,
and P/J8302A on the Finisher Main
PWB.
2. Check for continuity at the following:
J8391A-3 <=> P/J8302A-4
J8391A-2 <=> P/J8302A-5
J8391A-1 <=> P/J8302A-6
Are these conductive?
27 Check for +5 V to the Compile Exit Sensor.
Is there +5 V across J8302A-6 <=>
J8302A-4 on the Finisher Main PWB?
28 Check Compile Exit Sensor signal.
Does the voltage across P8302A-5 <=>
P8302A-4 on the Finisher Main PWB
change when the actuator is operated?

Jam at H - F4-56 Compile Exit SNR Static

Remaining paper is detected by the Compile Exit Sensor.
Applicable Error Codes
Jam at H - F4-56 Compile Exit SNR Static
Static Jam at H (Compile Exit Sensor) Troubleshooting Reference
Applicable Parts
Compile Exit Sensor
Compiler Harness
Main Sensor Harness
Finisher Main PWB
Main Drive Harness
Exit Motor
Error Messages, Codes, and Procedures
Yes
Go to Step 9.
Go to Step 10.
Replace the
Finisher Main
PWB
(page 3-248).
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (1/2) Wiring (page 5-40)
Finisher Motors Wiring (page 5-42)
PL25.10 Finisher Eject (2/3) (page 4-62)
PL25.11 Finisher Eject (3/3) page 4-64)
PL25.13 Finisher Transport (2/2) (page 4-68)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
No
Repair the Main
Sensor Harness.
Replace the
Finisher Main
PWB
(page 3-248).
Replace the
Compile Exit
Sensor
(page 3-189).
3-115