Jam At H - F4-61 Set Eject Jam - Fuji Xerox Phaser 5500 Service Manual

Jam at H - F4-61 Set Eject Jam

Paper failed to clear the Compile Tray No Paper Sensor on time. Set Eject failed.
Applicable Error Codes
Jam a H - F4-61 Set Eject Jam
Jam at H (Compile Tray No Paper Sensor) Troubleshooting Reference
Applicable Parts
Eject Roller Shaft
Main Drive Harness
Eject Clamp Motor
Eject Motor
Finisher Main PWB
Compiler Harness
Main Sensor Harness
Compile Exit Sensor
Compile No Paper Sensor
Jam at H (Compile Tray No Paper Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Check the paper path.
Is the Eject Roller clean, rotate
smoothly, and installed correctly?
2
Test the Eject Clamp Motor.
Run the Service Diagnostics Eject Clamp
Motor Up and Down tests.
Does the motor rotate properly?
3 Check Main Drive Harness connections.
Are P/J8339 and P/J 8304 connected?
4 Print a Test Print.
Does the error still occur?
5 Check Main Drive Harness continuity.
1. Disconnect P/J8339 and P/J 8304.
2. Check for continuity at the following:
J8339-1 <=> J8304-33
J8339-2 <=> J8304-31
Are these conductive?
6
Replace the Eject Clamp Motor.
Print a Test Print.
Does the error still occur?
3-118
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (1/2) Wiring (page 5-40)
Finisher Motors Wiring (page 5-42)
Finisher Clutch and Solenoids (page 5-43)
Finisher Compiler Tray Wiring (page 5-44)
PL25.9 Finisher Eject (1/3) (page 4-60)
PL25.10 Finisher Eject (2/3) (page 4-62)
PL25.11 Finisher Eject (3/3) page 4-64)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Yes
Go to Step 2.
Go to Step 7.
Go to Step 5.
Go to Step 5.
Go to Step 6.
Replace the
Finisher Main
PWB
(page 3-248).
Phaser 5500 Printer Service Manual
No
Clean or replace
the Eject Roller.
Go to Step 3.
Connect and go
to Step 4.
Problem solved.
Repair the Main
Drive Harness.
Problem solved.