Jam At Tray 5 - C4-0 Tray 5 - Fuji Xerox Phaser 5500 Service Manual

Jam at Tray n (Feed Out Sensor #4) Troubleshooting Procedure (Continued)
Step Actions and Questions
10
Check continuity between the Tray 4-5 and
the Engine Logic Board.
Is there continuity on each wire
between P/J541 <=> P/J413?
11 Check for +24 V at the Tray 4-5 PWB
Is their +24 V across P/J541-7 (+) <=>
ground?
12 Test the Feed Out Sensor #5.
1. Open Door C.
2. Run the Service Diagnostics Tray 5
Feed Out Sensor test.
Does the sensor change state?
13 Check the Feed Out Sensor #5 connection.
Are P/J825, P/J842 and P/J548
connected?
14 Check continuity between the Feed Out
Sensor #5 and the Tray 4-5 PWB.
Is there continuity on each wire
between P/J825 <=> P/J548?
15 Check for +5 V at the Feed Out Sensor #5.
Is there +5 V across the sensor
connector's Pin 3 <=> ground?
16
Check connections between the Tray 4-5
PWB and Engine Logic Board.
Are P/J541 and P/J413 connected?
17
Check continuity between the Tray 4-5
PWB and the Engine Logic Board.
Is there continuity on each wire
between P/J541 <=> P/J413?
18
Check for +24 V at the Tray 4-5 PWB
Is their +24 V across P/J541-7 (+) <=>
ground?

Jam at Tray 5 - C4-0 Tray 5

Paper did not reach the Tray 5 Feed Out Sensor #5 on time.
Applicable Error Code
Jam at Tray 5 - C4-0 Tray 5
Error Messages, Codes, and Procedures
Yes
Go to Step 11.
Replace the Tray
4-5 PWB
(page 3-29).
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 14.
Go to Step 15.
Replace Feed Out
Sensor #5
(page 3-22).
Go to Step 17.
Go to Step 18.
Replace the Tray
4-5 PWB
(page 3-29).
No
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 13.
Connect the
sensor.
Repair the wiring.
Go to Step 16.
Connect P/J541
and P/J413.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
3-65