Jam At F Or H - F4-5N Compile Exit Snr Off - Fuji Xerox Phaser 5500 Service Manual

Jam at F or H - F4-5n Compile Exit SNR OFF

Paper did not clear the Compile Exit Sensor on time.
Applicable Error Codes
Jam at F - F4-51 Compile Exit SNR OFF Jam A
Jam at F - F4-55 Compile Exit SNR OFF Jam B
Jam at F or H (Compile Exit Sensor OFF) Troubleshooting Reference
Applicable Parts
Lower Exit Roller
Compile Exit Sensor
Compiler Harness
Main Sensor Harness
Finisher Main PWB
Main Drive Harness
Exit Motor
Jam at F (Compile Exit Sensor OFF) Troubleshooting Procedure
Step Actions and Questions
1 Check the paper path.
Open Door G.
Is the Lower Exit Roller clean, installed
correctly and roll freely?
2 Test the Compile Exit Sensor.
Run the Service Diagnostics Compile Exit
Sensor test.
Does the sensor state change?
3
Check the Compile Exit Sensor
connection.
Are P/J8320 and P/J8391 connected?
4
Print a Test Print.
Does the error still occur?
5 Check Main Sensor Harness connections.
Are P/J8391 and P/J8302A connected?
6 Print a Test Print.
Does the error still occur?
Error Messages, Codes, and Procedures
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (1/2) Wiring (page 5-40)
Finisher Motors Wiring (page 5-42)
PL25.10 Finisher Eject (2/3) (page 4-62)
PL25.11 Finisher Eject (3/3) page 4-64)
PL25.13 Finisher Transport (2/2) (page 4-68)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Yes
Go to Step 2.
Go to Step 11.
Go to Step 5.
Go to Step 5.
Go to Step 7.
Go to Step 7.
No
Clean or replace
the Lower Exit
Roller.
Go to Step 2.
Connect and go
to Step 4.
Problem solved.
Connect and go
to Step 6.
Problem solved.
3-109