Close Door D - Door D Is Open - Fuji Xerox Phaser 5500 Service Manual

Door C Open (Door C Interlock Switch) Troubleshooting Procedure (Continued)
Step Actions and Questions
6 Check the Tray 4-5 PWB connection.
Are P/J541 and P/J413 connected?
7 Check continuity between the Tray 4-5
PWB and the Engine Logic Board.
1. Disconnect P/J541 and P/J413.
2. Check for continuity at the following:
P/J541-1 <=> P/J413-A1
P/J541-2 <=> P/J413-A2
P/J541-3 <=> P/J413-A3
P/J541-4 <=> P/J413-A4
P/J541-5 <=> P/J413-A5
P/J541-6 <=> P/J413-A6
P/J541-7 <=> P/J413-B1
P/J541-8 <=> P/J413-B2
P/J541-9 <=> P/J413-B3
P/J541-10 <=> P/J413-B4
P/J541-11 <=> P/J413-B5
P/J541-12 <=> P/J413-B6
Are these conductive?
8 Check for +24 V to the Tray 4-5 PWB.
Is there +24 V across P/J541-7 (+) <=>
ground?

Close Door D - Door D is Open

The Door D Interlock Switch in the Duplex Unit indicates that Door D is open.
Door D Open (Door D Interlock Switch) Troubleshooting Reference
Applicable Parts
Door D Interlock
SW
Duplex PWB
Engine Logic
Board.
Door D Open (Door D Interlock Switch) Troubleshooting Procedure
Step Actions and Questions
1
Check Door D operation.
Does Door D open and close normally?
3-240
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
Duplex Unit P/J Locator (page 5-12)
Duplex Unit Wiring (page 5-13)
PL23.1 Transportation (page 4-34)
Phaser 5500 Printer Service Manual
Yes
Go to Step 7.
Go to Step 8.
Replace the Tray
4-5 PWB
(page 3-29).
Yes
Go to Step 2.
No
Connect P/J541
and P/J413.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
No
Correct the
installation.