Fuji Xerox Phaser 5500 Service Manual page 261

Punch Failure (Side Registration Sensors) Troubleshooting Procedure (Continued)
Step Actions and Questions
10
Check the harness connections.
Are P/J8307, P/J8333 and P/J8350 (for
Side Regi Sensor 1), and P/J8351 (for
Side Regi Sensor 2) connected?
11 Print a Test Print.
Does the error still occur?
12 Check Main Punch Sensor continuity.
Disconnect P/J8307 and P/J8333.
Is there continuity on each wire
between J8307 <=> J8333?
13 Check Side Regi Sensor continuity.
1. Disconnect P/J8333, P/J8350 (Side
Regi Sensor 1), and P/J8351 (Side Regi
Sensor 2).
2. Check for continuity at the following:
P/J8333-13 <=> P/J8350-3
P8333-14 <=> P/J8350-2
P8333-15 <=> P/J8350-1
P8333-16 <=>P/J8351-3
P8333-17 <=> P/J8351-2
P8333-18 <=> P/J8351-1
Are these conductive?
14 Check for +5 V at Side Regi Sensor 1
Is there +5 V between P/J8307-A10 <=>
P/J8307-A12?
15 Check for +5 V at Side Regi Sensor 2
Is there +5 V between P/J8307-A7 <=> P/
J8307-A9?
16 Replace the Side Registration Sensor 1.
Print a Test Print.
Does the error still occur?
17 Replace the Side Registration Sensor 2.
Print a Test Print.
Does the error still occur?
18 Replace the Finisher Main PWB.
Does the error still occur?
Error Messages, Codes, and Procedures
Yes
Go to Step 12.
Go to Step 12.
Go to Step 13.
Go to Step 14.
Go to Step 16
Go to Step 17
Go to Step 18.
Go to Step 18.
Replace the
Engine Logic
Board
(page 8-89).
No
Connect and go
to Step 11.
Problem solved.
Repair the Main
Punch Sensor
Harness.
Repair the Punch
Unit Harness.
Go to Step 18
Go to Step 18.
Problem solved.
Problem solved.
Problem solved.
3-183