Fuji Xerox Phaser 5500 Service Manual page 225

Tray 6 Failure Troubleshooting Procedure (Continued)
Step Actions and Questions
25
Test for +24.5 V to the Nudger Solenoid.
Run the Service Diagnostics Nudger
Solenoid High Power test.
Is there +24.5 V across PF06-13 <=> P/
JF04-2 on the Tray 6 PWB?
26 Test for +14.7 V Nudger Solenoid.
Run the Service Diagnostics Nudger
Solenoid Low Power test.
Is there +14.7V across PF06-13 <=> P/
JF04-2 on the Tray 6 PWB?
27 Replace the Nudger Solenoid.
Does the error still occur?
28 Test the Feed/Lift Motor.
Run the Service Diagnostics Tray 6 Lift
Motor test.
Does the Tray raise?
29 Check the harness connections.
Are PF58 and PF56 on the Feeder and
Main Harness, and JF06 on the Tray 6
PWB connected?
30 Check the repair.
Does the error still occur?
31 Check Feeder Harness continuity.
1. Disconnect PF58 and JF56.
2. Check for continuity at the following:
PF58-1 <=> JF56-1
PF58-2 <=> JF56-2
PF58-3 <=> JF56-3
PF58-4 <=> JF56-4
PF58-5 <=> JF56-5
PF58-6 <=> JF56-6
Are these conductive?
32 Check Main Harness continuity.
1. Disconnect PF56 and JF06.
2. Check for continuity at the following:
PF56-1 <=> JF06-1
PF56-2 <=> JF06-3
PF56-3 <=> JF06-2
PF56-4 <=> JF06-6
PF56-5 <=> JF06-4
PF56-6 <=> JF06-5
Are these conductive?
Error Messages, Codes, and Procedures
Yes
Go to Step 26.
Go to Step 27.
Go to Step 36.
Go to Step 36.
Go to Step 31.
Go to Step 31.
Go to Step 32.
Go to Step 33.
No
Replace the Tray
6 PWB
(page 3-67).
Replace the Tray
6 PWB
(page 3-67).
Problem solved.
Go to Step 29.
Connect and go
to Step 30.
Problem solved.
Repair the Feeder
Harness.
Repair the Main
Harness.
3-147