Fuji Xerox Phaser 5500 Service Manual page 255

Eject Clamp Failure (Eject Clamp Home Sensor) Troubleshooting Reference
Applicable Parts
Eject Clamp Home
Sensor
Eject Clamp Sensor
Harness
Finisher Main PWB
Eject Clamp Motor
Eject Clamp Motor
Harness
Eject Clamp Failure (Eject Clamp Home Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Check the Eject Clamp operation.
Rotate the Eject Clamp Motor.
Does the Eject Clamp move smoothly?
2 Test the Eject Clamp Home Sensor.
Run the Service Diagnostics Eject Clamp
Home Sensor test.
Does the sensor change state?
3 Check Eject Clamp Sensor Harness
connection.
Are P/J8324 and P/J8302B connected?
4 Print a Test Print.
Does the error still occur?
5
Check Eject Clamp Sensor Harness
continuity.
1. Disconnect P/J8324 and P/J8302B.
2. Check for continuity at the following:
P/J8324-3 <=> P/J8302B-6
P/J8324-2 <=> P/J8302B-7
P/J8324-1 <=> P/J8302B-8
Are these conductive?
6
Check for +5 V to the Eject Clamp Home
Sensor.
Is there +5 V across J8302B-8 <=>
J8302B-6 on the Finisher Main PWB?
7 Check the Eject Clamp Home Sensor
signal.
Does the voltage across P8302B-7 <=>
P8302B-6 on the Finisher Main PWB
change when the sensor is blocked?
Error Messages, Codes, and Procedures
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Input Drive P/J Locator (page 5-32)
Finisher Sensors (2/2) Wiring (page 5-41)
Finisher Clutch and Solenoids Wiring (page 5-43)
PL25.9 Finisher Eject (1/3) (page 4-60)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Yes
Go to Step 2.
Go to Step 8.
Go to Step 5.
Go to Step 5.
Go to Step 6.
Go to Step 7.
Replace the
Finisher Main
PWB
(page 3-248).
No
Correct the
installation.
Go to Step 3.
Connect and go
to Step 4.
Problem solved.
Repair the Eject
Clamp Sensor
Harness.
Replace the
Finisher Main
PWB
(page 3-248).
Replace the Eject
Clamp Home
Sensor
(page 3-175).
3-177