Controller Nvram Access Menu; Engine Logic Board Replacement Menu - Fuji Xerox Phaser 5500 Service Manual

Finisher Solenoid/Clutch Tests (Continued)
Test
Transfer Gate
Solenoid (Path Out)
Transfer Gate
Solenoid (Path In)
Sub Paddle Solenoid
Set Clamp Clutch

Controller NVRAM Access Menu

This menu allows you to reset the PostScript NVRAM locations to factory defaults.
Controller NVRAM Utilities
Utility
Reset PostScript NVM
Factory Reset
NVRAM

Engine Logic Board Replacement Menu

These commands transfer the contents of a defected Engine Logic Board's NVRAM
to the Image Processor Board and return it to the new Engine Logic board after
installation.
Engine Logic Board Replacement Utilities
Utility
Save from Engine
Board
Restore to Engine
Board
The following provides instructions for using these utilities during an Engine Logic
Board replacement.
A-22
Action / Requirement
Activate the Transfer Gate Solenoid moving the Transfer Gate to
direct paper to the Stacker Upper Tray.
Activate the Transfer Gate Solenoid moving the Transfer Gate to
direct paper to the Stacker Lower Tray.
Activate the Sub Paddle Solenoid.
Energize the Finisher Set Clamp Clutch.
Action / Requirement
Resets the PS NVRAM. You are prompted to confirm your decision
to perform a reset operation.
Reset NVRAM to factory defaults. This utility is password protected.
The password to access the reset functions is 4370. Use the Front
Panel buttons to enter the password. After you enter the password,
you are prompted to confirm your decision to perform a reset.
Action / Requirement
Saves the NVRAM contents of the Engine Logic Board to a
reserved area of NVRAm on the Image Processor Board.
Writes the Engine Logic Board NVRAM data to the replacement
board from the NVRAM of the Image Processor Board.
Phaser 5500 Printer Service Manual