Storm-Control Multicast (Configuration) - Dell Z9500 Reference Manual

Version
8.3.7.0
7.6.1.0
7.5.1.0
7.4.1.0
6.5.1.0

storm-control multicast (Configuration)

Configure the packets per second (pps) of multicast traffic allowed into the C-Series and S-Series
networks only.
Z9500
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-
control multicast packets_per_second in command.
Parameters
packets_per_se
cond in
Defaults none
Command CONFIGURATION (conf)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
Usage Broadcast traffic (all 0xFs) should be counted against the broadcast storm control
Information meter, not against the multicast storm control meter. It is possible, however, that
1714
Description
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
E-Series Only: Added the percentage decimal value
option.
Introduced on the E-Series.
Enter the packets per second of multicast traffic allowed into
the network. The range is from 0 to 33554368.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-series and S-Series.
Storm Control