Ip Route-Import - Dell Z9500 Reference Manual

Related

ip route-import

Commands
ip route-import
Imports IPv4 routes that are leaked by another VRF using the tag specified by that VRF during export of
these routes.
Syntax
ip route-import tag [route-map—name]
Parameters
route-import
tag
route-map-
name
Defaults N/A
Command
Modes
CONFIGURATION
VRF MODE
Command
Version
History
9.7(0.0)
Usage It is possible to configure multiple import conditions per VRF depending on the
Information exporting VRF.
The export-target and import-target support only the match protocol and match
prefix-list options. Other options that are configured in the route-maps are
ignored.
1788
– imports routes from another VRF.
Enter the keyword route-import to import routes into the
VRF.
Enter a tag (ASN number) to specify an import route target
for importing routes from another VRF.
To import leaked routes from another VRF, you must use the
same ASN number that is specified as the export route target
at the source VRF.
Enter the name of the route-map to filter the imported
routes.
NOTE: You must use the route-map attribute while
importing routes from the global RTM. Route-maps
enable you to filter routes at the import end based on
the matching criteria that you define in the route-map.
Description
Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, and Z9500.
Virtual Routing and Forwarding (VRF)