Ipv6 Route-Import - Dell Z9500 Reference Manual

Only Active routes are eligible for leaking. For example, if one VRF has two routes
corresponding to BGP and OSPF, in which the BGP route is not active, the OSPF
route takes precedence over BGP. Even though the Target VRF has specified
filtering options to match BGP, the BGP route is not leaked as that route is not
active in the Source VRF.
Related

ipv6 route-import

Commands
ipv6 route-import
Imports IPv6 routes that are leaked by another VRF using the tag specified by that VRF during export of
these routes.
Syntax
ipv6 route-import tag [route-map-name]
Parameters
route-import
tag
route-map-
name
Defaults N/A
Command
Modes
VRF MODE
CONFIGURATION
Command
Version
History
9.7(0.0)
1790
– imports IPv6 routes from another VRF.
Enter the keyword route-import to import IPv6 routes into
the VRF.
Enter a tag (ASN number) to specify an import route target
for importing routes from another VRF. To import leaked
routes from another VRF, you must use the same ASN
number that is specified as the export route target at the
source VRF.
Enter the name of the route-map to filter the imported
routes.
NOTE: You must use the route-map attribute while
importing routes from the global RTM. Route-maps
enable you to filter routes at the import end based on
the matching criteria that you define in the route-map.
Description
Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, and Z9500.
Virtual Routing and Forwarding (VRF)