Show Config - Dell Z9500 Reference Manual

Command VRRP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.16.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage
To guarantee that a VRRP group becomes MASTER, configure the VRRP group's
Information
virtual address with same IP address as the interface's primary IP address and
change the priority of the VRRP group to 255.
If you set the priority command to 255 and the virtual-address is not equal
to the interface's primary IP address, an error message appears.

show config

View the non-default VRRP configuration.
Z9500
Syntax
show config [verbose]
Parameters
verbose
Command VRRP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
1834
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter the keyword verbose to view all VRRP
group configuration information, including defaults.
Description
Introduced on the Z9500.
Virtual Router Redundancy Protocol (VRRP)