Member - Dell Z9500 Reference Manual

member

Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack
compatible command in its configuration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface
command.
Parameters
interface
Defaults Not configured.
Command CONF-IF-VLAN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.11.1
8.2.1.0
7.6.1.0
Usage You must enable the stackable VLAN (using the vlan-stack compatible
Information
command) on the VLAN prior to adding a member to the VLAN.
Related vlan-stack compatible
Commands
1774
Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 512.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Description
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
— enables stackable VLAN on a VLAN.
VLAN Stacking