Show Ntp Status - Dell Z9500 Reference Manual

show ntp status

Display the current NTP status.
Z9500
Syntax
show ntp status
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage The following describes the show ntp status command shown in the Example
Information
below.
Field
"Clock is..."
"frequency is..."
"reference time
is..."
"clock offset is..."
"root dispersion
is..."
"peer mode is..."
System Time and Date
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
States whether or not the switch clock is synchronized,
which NTP stratum the system is assigned and the IP
address of the NTP peer.
Displays the frequency (in ppm), stability (in ppm) and
precision (in Hertz) of the clock in this system.
Displays the reference time stamp.
Displays the system offset to the synchronized peer and the
time delay on the path to the NTP root clock.
Displays the root and path dispersion.
State what NTP mode the switch is. This should be Client
mode.
1751