Dell Z9500 Reference Manual page 1781

In Example 2, the tag protocol identifier (TPID) is set to 8848. The "Te 2/10" port is
configured to act as a VLAN-Stack access port, while the "Te 1/0" port acts as a
VLAN-Stack trunk port, switching stackable VLAN traffic for VLAN 10, while also
switching untagged traffic for VLAN 30 and tagged traffic for VLAN 40. (To allow
VLAN 30 traffic, the native VLAN feature is required, by executing the portmode
hybrid command. Refer to
Example 1
Dell(conf-if-te-0/42)#switchport
Dell(conf-if-te-0/42)#vlan-stack trunk
Dell(conf-if-te-0/42)#show config
!
interface TenGigabitEthernet 0/42
Dell(conf-if-te-0/42)#interface vlan 100
Dell(conf-if-vl-100)#vlan-stack compatible
Dell(conf-if-vl-100-stack)#member gigabitethernet 0/42
Dell(conf-if-vl-100-stack)#show config
!
interface Vlan 100
Dell(conf-if-vl-100-stack)#interface vlan 20
Dell(conf-if-vl-20)#tagged tengigabitethernet 0/42
Dell(conf-if-vl-20)#show config
!
interface Vlan 20
Dell(conf-if-vl-20)#do show vlan
Codes: * - Default VLAN, G - GVRP VLANs
Q: U - Untagged, T - Tagged
* 1
Dell(conf-if-vl-20)#
Example 2
Dell(config)#vlan-stack protocol-type 88A8
Dell(config)#interface tengigabitethernet 2/10
Dell(conf-if-te-2/10)#no shutdown
Dell(conf-if-te-2/10)#switchport
Dell(conf-if-te-2/10)#vlan-stack access
Dell(conf-if-te-2/10)#exit
Dell(config)#interface tenGigabitethernet 1/0
Dell(conf-if-te-1/0)#no shutdown
Dell(conf-if-te-1/0)#portmode hybrid
Dell(conf-if-te-1/0)#switchport
Dell(conf-if-te-1/0)#vlan-stack trunk
Dell(conf-if-te-1/0)#exit
VLAN Stacking
no ip address
switchport
vlan-stack trunk
no shutdown
no ip address
vlan-stack compatible
member TenGigabitEthernet 0/42
shutdown
no ip address
tagged TenGigabitEthernet 0/42
shutdown
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status Description
Inactive
20 Active
100 Active
portmode hybrid in Interfaces.
Q Ports
T Te 0/42
M Te 0/42
1781