Dell Z9500 Reference Manual page 1836

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.4.(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage The following describes the show vrrp brief command shown in the following
Information
example.
Item
Interface
Grp
Pri
Pre
State
Master addr
1836
Description
Introduced on the S6000-ON.
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Lists the interface type, slot and port on which the VRRP
group is configured.
Displays the VRRP group ID.
Displays the priority value assigned to the interface. If the
track command is configured to track that interface and
the interface is disabled, the cost is subtracted from the
priority value assigned to the interface.
States whether preempt is enabled on the interface.
• Y = Preempt is enabled.
• N = Preempt is not enabled.
Displays the operational state of the interface by using one
of the following:
• NA/IF (the interface is not available).
• MASTER (the interface associated with the MASTER
router).
• BACKUP (the interface associated with the BACKUP
router).
Displays the IP address of the MASTER router.
Virtual Router Redundancy Protocol (VRRP)